2.8-Inch 480*640 TFT LCD Screen 16.7m

• Customization: Available
• Screen Size: ≤17"
• Application: Indoor, Advertising, Outdoor, Surveillance
• Model NO.: 2.8-816
• Aspect ratio: 5:4
• Optimum Resolution: 480*640
• Type: TFT
• Widescreen: Widescreen
• Response Time: 40ms
• 3D: Not 3D
• Interface Type: Mipi Dsi Interface
• Brightness: 300CD/M 2
• Frame Frequency: Fframe 60 Hz Frame Inversion
• Operating Temperature: -20 - 70 ºC
• Storage Temperature: -30 - 80 ºC
• Transport Package: Carton
• Specification: Glass electronic products of 2.8" display
• Trademark: jinzhaohui
• Origin: China
• HS Code: 8528591090
• Production Capacity: 9, 000PCS/Year

Product Description

Features
 

 

Display Mode	Transmissive type
Display Mode	2.8'' Active matrix TFT-LCD
3.4'' Active matrix TFT-LCD	Graphic 480*3(RGB)*640t-matrix
Display color	16.7M colors
Interface	MIPI DSI interface
Viewing Direction	ALL 0 'CLOCK

 

Mechanical Specification

 

Item	Specifications
Dimensional Outline	50.3 (W)*69.6(H)*2.54 mm FPC not include
Resolution	480(W)*3(RGB) *640(H)pixels dots
LCD Active Area	43.2(W)* 57.6(H) mm
Pixel Size	0.09(W)* 0.09(H) mm
Weight	T.B.D g

MIPI-DSI interface

DSI-CLK Lanes

DSI-CLK+/- lanes can be driven into three different power modes: Low Power Mode (LPM LP-11), Ultra Low PowerMode (ULPM) or High Speed Clock Mode (HSCM).Clock lanes are in a single end mode (LP = Low Power) when there is entering or leaving Low Power Mode(LPM) orUltra Low Power Mode (ULPM).
Clock lanes are in the single end mode (LP = Low Power) when there is entering in or leaving out High Speed Clock
Mode(HSCM).
These entering and leaving protocols are using clock lanes in the single end mode to generate an entering orleaving sequences
The principal flow chart of the different clock lanes power modes is illustrated below.

DSI-CLK+/- lanes can be driven to the Low Power Mode(LMP),when DSI-CLK lanes are entering LP-11 State Code
in three different ways:After SW Reset,HW Reset or Power On Sequence->LP-11After DSLCLK+/- lanes are leaving Ultra Low Power Mode (ULPM,LP-00 State Code)=>LP10=>LP-11(LPM)This sequence is illustrated below.
 

Reliability
 

Note 1: Ta is the ambient temperature of samples.

Note 2: Ts is the temperature of panel's surface.

Note 3: In the standard condition, there shall be no practical problem that may affect the

display function. After the reliability test, the product only guarantees operation,

but don't guarantee all of the cosmetic specification.

Note 4: Before cosmetic and function test, the product must have enough recovery time,

at least 2 hours at room temperature.